CONTROL FAN, LIGHT, AND MANY MORE IN HOME USING UR TV OR VCR OR DVD REMOTE CONTROL

Connect this circuit to any of your home appliances (lamp, fan, radio, etc) to make the appliance turn
on/off from a TV, VCD or DVD remote control. The circuit can be activated from up to 10 metres.
The 38kHz infrared (IR) rays
generated by the remote control are received by IR receiver module TSOP1738 of the circuit.
Pin 1 of TSOP1738 is connected to ground, pin 2 is connected to the power supply through resistor R5 and
the output is taken from pin 3. The output signal is amplified by transistor T1 (BC558).

The amplified signal is fed to clock pin 14 of decade counter IC CD4017 (IC1).
Pin 8 of IC1 is grounded, pin 16 is connected to Vcc and pin 3 is connected to LED1 (red), which
glows to indicate that the appliance is ‘off.’
The output of IC1 is taken from its pin 2. LED2 (green) connected to pin 2 is used to indicate the ‘on’ state
of the appliance. Transistor T2 (BC548) connected to pin 2 of IC1 drives relay RL1.
Diode 1N4007 (D1) acts as a freewheeling diode.
The appliance to be controlled is connected between the pole of the relay and neutral terminal of mains.
It gets connected to live terminal of AC mains via normally opened (N/O) contact when the relay energises